 |
|
 |
June 01 2009 | The second plastic plate
All this is very well, but of course I got an extra thickness with the metal bit. So I actually pasted another thin plasticard sheet over the first one so that everything would be level with the dorro. the fact I paste it on already bent plastic should also avoid any inconvenient later when fitting that armour plate later
June 01 2009 | The door on the rear of the turret
Well it's time to place the door on the rear armour plate behind the turret. first, let's dig a hole for the actual door..
May 25 2009 | The rear part of the gun
I will begin by correcting the hull and adding the details. first I will begin with the curve section of the boat that is located behind the turret.
So let's take some ruler, and a compass and let's cut platsic for it. here is also the position of that sepecial piece
May 25 2009 | The rear part of the gun
I will begin by correcting the hull and adding the details. first I will begin with the curve section of the boat that is located behind the turret.
So let's take some ruler, and a compass and let's cut platsic for it. here is also the position of that sepecial piece
May 25 2009 | Checking the Masséna after 6 months of rest
Dust and cobwebs everywhere, and then looking back on my plans, I found quite a few details I never see before. oh well, time to work on that old thing again
December 11 2008 | The final pieces
Here they are straight from the filtering, in the water bath for cleaning, should look good :)
December 11 2008 | Halfway through the etching process
Halfway through the etching process thanks to my homemade machine! But then I had to do that in 2 steps as my bloody garden chairs crushed the machine while falling :)
December 11 2008 | Some new plates
Here are the plates for the portholes -all the small pieces, enough to detail the portholes.
